Do you spend hours in front of a mirror with your curling iron or flat iron, trying to coax a little curl in your hair? When you finally manage to get romantic and flowing locks like, seems to fall straight back in an hour or so. It can be a frustrating experience.
If you want to add some curl and wave hair uncurly course, you will need to properly prepare hair to accept the rotor. Start with the wet and damp hair and apply a light foaming product designed for curly hair. These products are formulated to assist in the process of waving. Gels are not recommended because they tend to weigh down your tresses. Mousse or other foaming products are lightweight and hold up the hair enough to give some control.
Apply a styling foam on wet hair, massage it from root to tip with your fingertips. Allow to dry completely, because your hair is naturally bounce when dry, and it is also lighter, which helps the rotor to take hold.
When your hair is dry, divide it into parts to be crimped. most want to curl up, most of you can use. Start the section furthest from your face so you can always see what's left to do. Wrap each section around barrel curling or flat iron, and hold for a few seconds to allow heat to penetrate. Gently remove the bar without pulling or twisting. If you do not have enough curl, repeat the process for a few seconds until you have the time worked for the rotor you want.
can finish off your style with a light finishing spray or hair spray. Make sure to always use products designed for curly hair, because they are usually formulated to stand up to the flattening effects moisture.
Do not over brush or your finger to play with your hair too much, because it will cause the rotor to come off. However, you can dress up the end of the spray during the day, and scrunch it a little with your finger tips. Once you get the hang of it, a little prep work is all that needs to be transformed into straight hair soft and buoyant curls.
0 comments:
Post a Comment